Nedis Socket Splitter 2 Sockets Euro Connector

Product Information

I really hope all of the above is helpful to you and has answered any questions you may have had about 2 pin plugs and adapters required for electric toothbrushes and similar products like shavers. It is very detailed and legally correct description of why we have 2 pin plugs on electric toothbrushes. KS: there is ONE problem that you might face, and it does not matter if you have a shaver or a toothbrush.

Once a suitable supply has been found the next task is to isolate the supply to the circuit you are using! If in any doubt, the power to the entire house is turned off. Ideally look for a model with double wound isolating transformer, integral overload protection and shutters on the plug inlets to prevent any accidental splashing. Using electrical equipment in bath or shower rooms has always needed great care to ensure safety due to the obvious risks of mixing water and electricity. I would say the hassle of rewiring a plug vs obtaining an adapter is less for many? Is it really safer?No, not quite. A 2 pin plug found on an electric toothbrush or shaver has pins that are closer together than a traditional 2 pin EU mains adapter. If either of the above are ignored, if any issues occur and you cannot produce a certificate for the works then there is a good chance that your home insurance will be invalid, so it certainly isn’t worth the risk. The cable was then secured in place using UPVC capping to not only hold it but also protect it from any damage that might from any potential future work. Wall chased out and cable placed in chase and protective UPVC pipe Step 3 – Install Fused Connection Unit (FCU) As previously mentioned, if you are sing a lighting circuit make sure it’s RCD protected. If it isn’t then you can’t use it.

When securing wires ensure that the retaining screw that holds the wire in place is tightened fully and that it has plenty of bare wire to clamp down on to. Once all the wires have been connected, the face plate is then screwed on to the pattress box, fixing it in place. Right now, aside from switching to a completely different brand of brush that can charge from the USB port in your van (Sonicare DiamondClean/DiamondClean Smart) you have no other option. What you may need though is a plug adapter. This is to convert the 2 pin adapter found on most charging stands in the UK and Europe to work with the power supply in the other country. You are best powering or charging each device independently as and when you need it. For example, connect and charge your toothbrush, when that is done, connect and charge your shaver or other appliance. Your comments

Buying more adapters will add to environmental problems caused by the prolifieration of waste electrical equipment. Many homes will however, have spare three pin plugs for reuse. Zone 2 – the area beyond zones 0 and 1, 0.6m horizontally and up to 2.25m vertically. Zone 2 also includes any recessed window with a sill next to the bath and also around the wash basin

In the UK there are very strict rules on who can and cannot do certain electrical jobs. This is mainly due to the fact that, as we all know, electricity is extremely dangerous and when working on or around it, it is essential that you know what you are doing. All wires are then set into the wall and capped with protective sleeving and then all chases are filled, smoothed off and the either painted or tiled over.

I have a multi-travel adaptor bought at an airport that accepts my UK bathroom plug without problem. But I also have 2 different ones that will not accept it, but they will accept the Euro-plug.(these are the large adaptors that can be used for multiple countries by extending different pin configurations out of the body To be honest, I would have done the same thing. Aside from the 2 pin AUS power connector, the UK voltage is very similar and will have likely been supported by your charging stand. Bathrooms are deivided into designated zones, 0, 1, 2 and regulations cover what type of light, heater other appliances can or cannot be installed in the different zones. However if you are installing in an upstairs then you may be able to locate a suitable supply in the loft. This is often the easiest route as everything should be much more accessible.