HOLULO Laser Tape Measure, 3 in 1 Digital Laser Distance Meters with LCD Display, 40M Laser Measure, 5M Tape Measure, Vertical Cross Line, Measuring Area/Volume/Distance/Pythagorean Circumference

Product Information

Unless stated in the Sale Details to be new, all Lots sold are preowned, used, or second-hand and are sold as seen. There are no manufacturer’s warranties or guarantees with any Lot unless expressly stated in the Sale Details. Measurements on hard-wired equipment in fixed installations, distribution boards, and circuit breakers fall within this category. Why use a CAT III rated tool in solar installations? It comes down to safety: yours. Don’t entrust your protection (or your team’s) to any tool that’s not adequately rated for the job. Related resources

Protection: Test Leads double insulated, recessed/shrouded; finger guards; CAT III – 1000V; Replace when damaged he obtains all certificates, permits, licences or authorisation necessary before any Lots can be used on any road.

This category refers to anything that is used for measuring voltages from specially protected secondary circuits. Examples of this include signal levels, special equipment, limited-energy parts of equipment, circuits powered by regulated low-voltage sources and other electronics. The auctioneer shall regulate the bidding and shall determine from time to time the appropriate increment needed to advance the bidding. Transient overvoltages are another name for these voltage spikes. Meters would regularly fail at voltages below their authorized values before the effect of these voltage spikes was understood. Measurements in Category I (CAT I) pose the lowest danger, with each category above CAT I posing a higher risk than the lower categories. Circuit measurements in Category IV (CAT IV) provide the highest danger during testing. The maximum overvoltage that the device is designed to withstand is determined by the rated working voltage and measurement category. Measurement Category Clearances

If any provision or part-provision of this agreement is or becomes invalid, illegal, or unenforceable, it shall be deemed modified to the minimum e Adaptability – A CAT IV rated meter can be used in any category, so it can be used for everything from an electronics hobby to residential electrical repair. These Conditions apply to govern the process leading to and the process of the auction, tender or private treaty sale and the sale of the Lots themselves, including the viewing of the Lots. These Conditions apply to the exclusion of any other terms that the Buyer seeks to impose or incorporate, or which would otherwise be implied by trade, custom, practice or course of dealing. In the event of any dispute about the bidding process a Buyer shall notify the Auctioneer immediately after the fall of the hammer, before bidding commences on the next Lot. The Auctioneer may confirm the sale or offer the Lot for sale again immediately. The Auctioneer’s decision will be final. Clint’s career has covered nearly the entire realm of audio and video production. After graduating at the top of his class with an Associates Degree in Recording Engineering, he began working for the famed Soundelux studios in 1994, one of the largest post-production companies specializing in audio for feature films & television. Working on a myriad of feature films, Clint honed his skills as a dialogue editor, foley editor, and sound designer. Years later, he moved into the expanding area of video editing, where he served as the company’s senior AVID video editor for three years.Circuit measurements in Category I have the lowest risk of causing a hazardous condition. Circuit measurements that are not connected to the electrical grid at all are included in this category (mains electricity). Electronics and circuits that are powered by low voltage are examples. This electrical measurement category is for measurements of voltages from specially protected secondary circuits. Such voltage measurements include signal levels, special equipment, limited-energy parts of equipment, circuits powered by regulated low-voltage sources, and electronics. These categories of use present very little chance for danger or overloading on any significant level. CAT II Measurement Category Never work alone when working on, or near, exposed and energized equipment. Stay safe and make sure you and your partner are aware of your environment, as well. If possible, don’t take measurements in humid or damp environments and make sure there are no atmospheric hazards around you (i.e. flammable dust or vapor). notify the Agent immediately if the Buyer becomes subject to any of the events listed in clauses 15.1.1 to 15.1.12 inclusive; and