Atyhao Costume Turtle Shell, Turtle Shell Costume Tortoise Shell Costume Cosplay Party Prop Halloween Cosplay Costume Party Dress Up Costume Accessories

Product Information

They're the kind of animal that likes to chill and have a good time, making them the perfect animal to dress up as the next time you have a costume party. Measure three inches from the edge of the cardboard oval and move around the cardboard drawing dots on the felt three inches from the edge of the cardboard all the way around the oval. Squeeze the paint onto a palette and apply a small amount of paint to the brush without using any water. It is useful to keep one edge of the oval on the edge of the felt to make it easier to cut from the felt. Pull the ribbons tight until the shell feels secure on your back, then tie knots in both ribbons to complete the shoulder straps.

Match the pointed edges of the half hexagons to the point edges of the whole hexagons where they are placed on the shell. It is helpful to place the squares all the way around the shell before gluing them to make sure that you have enough space to fit them all completely within the edges. Make sure it is dry to the touch, especially along the edges where it may have gathered excess paint. Leave enough space between the scales to allow the dark green felt to create lines between the scales.With sizes for kids and adults, anyone who likes turtles will have the chance to dress up like their favorite animal. It may be helpful to design these shapes once the others are in place to make sure that they fit appropriately to cover the top and bottom edges of the shell while leaving space between the shapes to allow the dark green bottom layer to create lines between the scales. They should have one short side for the bottom, then two sides splaying out at a diagonal and a rounded top. Using a pencil, hold the tip as close as you can keep it to the edge of the cardboard as you trace around the oval onto the felt.

You will want to cover both the inside and outside of the pan, as some of the inside may be visible. The points of the half hexagons should fit between the points of the top and center, and bottom and center whole hexagons. Push out from the inside of the pan to round out the bends in the roasting pan until the sides look more rounded like a turtle shell.Leaving enough space to allow the dark green felt to make lines between the scales, glue one hexagon above the center one, and the other hexagon below the center one. Cut slits in the top and bottom of the smaller oval where you will place the ribbons to create straps. If the shell shifts around too much as you move, take it off and shorten the straps about an inch on each side.